| Heating alloy |
Nickel-chromium (NiCr 80/20): electrical resistivity is typically about 1.09 μΩ·m at 20°C; maximum element temperature can be around 1,200°C in suitable conditions.
Iron-chromium-aluminum (FeCrAl): typically about 1.45 μΩ·m at 20°C; maximum element temperature can be around 1,400°C in suitable conditions.
Copper-nickel (CuNi 44): typically about 0.49 μΩ·m at 20°C; generally used for lower-temperature heating, with maximum element temperature around 600°C.
|
Match the alloy to the required element temperature, operating atmosphere, electrical resistance, and expected service life. Higher element-temperature capability does not mean the wire’s insulation can withstand that temperature. |
Values are typical reference figures. Alloy composition, wire diameter, atmosphere, duty cycle, and construction affect performance; confirm the exact material data before design. |
| Wire diameter |
Smaller diameters have higher resistance per unit length and less thermal mass. Larger diameters have lower resistance per unit length and are generally more mechanically robust. |
Calculate the required resistance first, then select a diameter that meets the electrical load and surface-loading requirements. Do not choose diameter from current alone. |
Check allowable current, wire surface temperature, heat dissipation, mechanical strength, and the manufacturer’s resistance-per-length data. A diameter suitable for one installation may overheat in another. |
| Wire shape |
Straight wire; helical coil; formed or serpentine element; insulated lead wire connected to a separate heating element. |
Use a straight or formed element where space and heat distribution call for a simple layout. A coil can provide more wire length in a compact space, but its pitch and diameter affect temperature and heat transfer. |
Keep coil turns from touching unless the design specifically requires contact. Check support, expansion clearance, vibration, and the risk of short circuits or localized hot spots. |
| Insulation type |
PTFE insulation is commonly rated for continuous service up to about 260°C. Silicone insulation is commonly rated around 180–200°C. Fiberglass sleeving or insulation may be rated around 450–550°C, depending on construction and treatment. |
Select insulation by the temperature at the insulation itself, not only by the heater element’s rated temperature. Use an uninsulated heating element only when the enclosure, supports, and electrical protection are designed for it. |
Ratings vary by product and test conditions. Check the exact continuous-temperature rating, voltage rating, abrasion resistance, chemical exposure, and whether the insulation is suitable for the installation environment. |
| Electrical sizing |
For a uniform wire, resistance can be estimated with R = ρL/A, where ρ is resistivity, L is wire length, and A is cross-sectional area. For a resistive heater, P = V²/R and I = P/V. |
Start with supply voltage and target power to determine the required resistance. Then use the alloy resistivity and wire cross-section to estimate the needed length; refine the result using temperature-dependent resistance data. |
Check the actual operating voltage, cold-start current, power tolerance, control method, and temperature rise. Resistance changes as the wire heats, so room-temperature calculations are only a starting point. |
| Final design verification |
Review the full assembly: alloy, diameter, element length, shape, supports, insulation, airflow, enclosure, and electrical connections. |
Choose the combination that meets the required power and temperature while staying within the limits of every component in the assembly. |
Confirm the applicable electrical and product-safety requirements. Test the finished assembly under representative operating conditions and use the supplier’s current technical data for final specifications. |